House Pictures Chat Corner - Show off your house pictures!

Today just relaxed, 1 1/2 hours of floor sweeping 4 times and laying out the impact sound insulation. Then, out of curiosity about how it looks over the area, I connected a few rows :cool: The protective film on the impact sound insulation is still on, so the entire package is movable (for the installation of the planks at the window front)

Here is the picture…



The floor plan can be seen here…
https://www.hausbau-forum.de/threads/grundriss-bau-bereits-begonnen.36387/

Here are two more pictures from the room above the children's room. The room behind the door is above the bedroom.

May I ask again about the dimensions of your attic? What width do you have and what height from the floor up to the cladding of the ridge? We're doing it quite similarly but currently still have little sense of space :).

Since yesterday, we are now (finally) in the house. The facade and the exterior area are still missing, and the heat pump is not yet running (hot water is currently provided via an electric heating rod). And in general, there are still boxes everywhere, and the tools are scattered around - but we are inside. There are a few photos as soon as the interior is presentable :D Until then, a photo of our day's work today: The photovoltaic system was installed on the roof. With dark tiles and a lot of sun, literally a hot affair. Also, a picture of our (freshly oiled) bamboo bathroom shelves, which I want to install the day after tomorrow. We still have to oil them twice tomorrow, then it should be fine.

Congratulations on moving in!

It will probably not be much different for me in 17 days on moving day. There is still so much to do and the days are just too short.

Today, 160m² of paving, a saddle gravel, L-stones, and edge stones were delivered to us. Everything is fully stacked, the landscapers are doing their best but it is just chaos inside and outside.

Attached is a picture of our half-finished smart home cabling. I spend several hours per residential unit alone on this (and there are four of them). Two of the three Controllino Max are already installed here, the SmartManager is still missing along with some dimming relays. The green relays are for the blinds (two per RF). But all switches are connected to the staging wiring (in my residential unit, which is the smallest with only 128 wires in total). The blue terminals are the potential distribution for +24V, the same is still to come for [-].

Anyone who has read carefully will have noticed that I have deviated from my specially handcrafted U-profiles and the somewhat smaller NTPLus LSA strips. Sometimes you only recognize the better solution during installation. This is new territory for me :cool:.

You would still need to make a suitable glasses holder...

You would still need to make a suitable glasses holder...

I have actually already done that (3D print attached with a magnet to the PIN wall in the office). I was tired of always looking for one of my three different pairs of glasses o_O