Bauhaus concrete villa with core insulation - experiences

Wardrobe and dressing room come from the carpenter. Surfaces Fenix. The color selection only really works together with the walls... Flush doors (walnut) are also made by the carpenter.

Dining chairs from Freifrau with the light brown upholstery. Also the bar stools. I don’t know the manufacturer of the table (280x100x75cm) right now. It is a manufactory at Lake Como. Also walnut. The lamp will be a Louis Poulsen Artichoke in copper rose (LED, 3000k, DALI). Whether 72cm diameter or 84cm we will decide when the table is in the house.

The lowboard and bookshelf in the living room are Kettnacker Soma in curry. We bought a display piece there before we had the floor slab. Meanwhile the display piece was sold again and we are getting a new one. But I also have personal connections to the furniture store... Today we configured an additional sideboard for the living room in pistachio. In some places in the house we have a "yellow-green concept".

In the office and bedroom, the furniture is from USM-Haller. The bed is from Schramm. It will get a different upholstery. Desk chairs probably Vitra.

Did I forget anything?

sorry for the quick interim question: how did you implement the lighting control? KNX only or DALI? I think I read something about DALI earlier in the thread. Why did you decide on that?

Thanks and good luck going forward, it looks great. We are now at the shell construction stage...

KNX has caught up tremendously in lighting control over the past few years. Actually, there is (almost) no longer any reason to rely on DALI in a single-family house.

However, these reasons apply to us. All our lamps have DALI ballasts and some can only be obtained that way (e.g., the dining table lamp).
Therefore, it was @easier@ for us to choose DALI.
Maybe can shed more "light on the subject."

Good luck with the further construction. Do you have pictures of the shell construction?

Thank you for the quick response

I am having difficulty deciding between KNX only vs. DALI Gateway. But that could fill its own threads.

One more additional question: do you use LED bulbs or also halogen? Halogen is superior in terms of color rendering and natural dimming behavior (LEDs try to imitate it with Dim2Warm), but LED is positioned as a future product...

PS: Pictures will come in a separate thread in due course

We only use LED. All 3000k.

Outside, earth was moved and today more foundations for the extension of the retaining wall as well as the enclosure were concreted. Tomorrow they are to be erected.

Hopefully we will get the electricity meter soon so that the photovoltaic system can be connected to the grid and we can use the sockets in the house.

Inside, the fitting-out is progressing well. The ceiling was a great decision. It is already installed in the bedroom.
The light blue tint comes from the window protection film.
Today I immediately installed the access point (NanoHD). With the Nano, the cable entry point is about 3.5 cm off-center. Of course, the distances to the lamps are measured exactly to fit.
As soon as we move away from construction power, the network will run permanently and the temporary setup will be dismantled.



If not during the construction phase, then when else would one have a good reason to stock up on new / additional tools?