Air-water heat pump current consumption and data

12 and 18 degrees are unusual values, aren't they? The truth is approximately 14-15 degrees. That’s how I set it and how I know it.

You have to try it out. But better to choose a higher switch-on temperature and slowly work your way down, rather than the other way around ;)

Just like that? ...and before that it was 5 degrees too warm for you? I don’t understand this measure as a solo measure?

Well, I don’t know which air-water heat pump he has, but if he limits the maximum flow temperature, he will probably only be able to achieve the required return temperature through the runtime, which would be positive. Since the temperature difference is so small at the outside temperature, it probably won’t get cold.

12 and 18 degrees are unusual values, aren't they? The truth is roughly around 14-15 degrees. That's how I set it and that's how I know it.

Then I heat partially into May without ERRs. Nah... [ATTACH alt="2BB5FDD0-B174-4986-9088-DDC30AAAC867.png" type="full"]57529[/ATTACH]

Then I sometimes heat into May without ERRs.

Nah...
[ATTACH alt="2BB5FDD0-B174-4986-9088-DDC30AAAC867.png"]57529[/ATTACH]

Yes, it's normal to heat until May, right? Of course much less, but there are also very cold nights then, etc...

I agree! If the cold nights are not over, heat up the Wärmi into May!