Air-water heat pump current consumption and data

The house was noticeably cooler this morning; I only had 21 degrees in the living room. I thought the heat pump would regulate itself, but apparently that was not sufficient. I then raised the heating curve by 2 degrees because I was cold. Now, after 24 hours, 42 kW of electricity went through 128 kW of heat including hot water at -14 degrees last night. Had 2 heating cycles lasting over 7 hours

Should be too warm with the solar gain from tomorrow, right? We have perfect weather with 10 hours of sunshine for the next 3 days. Just a pity that the photovoltaics are completely covered with snow.

What kind of nonsense is this? Has been running for 10 hours

Good question, is it still heating?

have consumed 32 kWh in the last 24 hours and thus generated 100 kWh of heat. Average temperature now at -9.5, lowest temperature last night -18, currently -14.

Good question, is it still heating?

consumed 32 kWh in the last 24 hours and thereby generated 100 kWh of heat. Average temperature now at -9.5, lowest temperature last night -18, currently -14.

Nah, judging by the consumption display of the inverter, the house consumption is currently at 450W, which means nothing is running. The heat pump should start, but something has happened with the flow temperature, no idea what.

I’ve just fired up the fireplace for now. The Luxmatic manual states that the compressor warm-up occurs during the initial operation and can take several hours.

No idea what happened there.

I'll have an update again tomorrow morning, really excited.

actually, according to the curve, your house should have cooled down to 5 degrees room temperature by now :D I think volcanic activities under the floor slab

Remove the fuse and see what happens next.