Dishwasher fronts

I have an 80s front because the solutions described here in the forum (e.g. doweling or milling space for the rail) were too complicated for me. Otherwise, I have everything in 40/40, but the deviation with the dishwasher doesn't bother me in retrospect.

I currently find handles at IKEA really difficult, luckily I still had METRIK handles at home which I use for the dishwasher and now also the refrigerator (here I found the upward-pointing BLANKETT neither nice nor practical)

Ok, thanks for the info! I will try a 20/20/40 front. Let's see if it turns out well

I have installed a Siemens SN65M037EU dishwasher in my new Ikea kitchen.

The dishwasher is screwed all the way down. The 60x80 front still slightly hits the dishwasher when opening. The end position is completely parallel to the floor. Only when opening there is an angle where the front rubs against the dishwasher (feels like 1-2mm too much front).

As far as I can see, there is no Vario hinge for my dishwasher.

Do you have any idea?

Regards,
Chris

I had no idea that only certain dishwashers could be installed, and so I simply ordered a new Siemens model SN65P082 beforehand,

after a lot of back and forth, I wanted to order the other dishwashers, with Vario rails that are also suitable for 80 cm fronts,
these are the two:
SX736X03ME
SN758X06TE

However, then I applied the Steffan method, meaning I completely unscrewed my Siemens SN65P082 and lo and behold,
it fits, I have 2x 40x60 fronts, even though I have the small machine and not an XLGSP, that is because I raised the kitchen by 2 cm, to 90 cm, here are pictures:

Thank you for the well-illustrated contribution. Can you also say how far the front could be mounted lower on the door if all tolerances are maximized, that is, whether it really has to be at least 9 cm base height?

Hi, hi,
here are a few more pictures, with the strip 10cm 80cm front,
whether it fits with a 9cm strip (9 80)???

The dishwasher, as mentioned, is not an XL model but only 81.5cm high. IKEA front is split into two (2x 40x60) and screwed on directly.




Blocks with double-sided adhesive tape are attached at the back to prevent the dishwasher from sliding back, since the dishwasher is only fixed on the right side; the washing machine goes on the left.

Hello,

I have installed a Neff GX662 (with Vario hinge) in my kitchen, which worked well except for the BLANKETT handle (which I unfortunately had to replace with another one). I now have a question about the plinths. The feet of the dishwasher protrude slightly in front of the METOD feet. How would you mount the plinth?

I underestimated the depth of the plinth brackets, but everything fit after all.