Floor plan multigenerational house conversion old barn

  • Erstellt am 2021-02-09 21:56:07

derclaus

2021-02-11 20:15:33
  • #1


Thank you for asking.

The staircase in the section is not correct. The drawing combined with the photo is misleading and I hadn’t noticed that. The staircase on the plan is completely fictitious; it was simply drawn as a possible staircase – while the staircase in the photo is currently only provisional and will be completely removed.

Answer: the ridge runs entirely parallel to the south side. The gables of the barn are accordingly to the east and west. On the east side it is free (and we don’t even extend our building there) and on the west side it is not visible, as it transitions into the “manor house.”
 

derclaus

2021-02-11 20:18:24
  • #2


I cannot imagine that & I think this would change the character of the barn too much. Gables in general would be possible – but we would prefer not to for cost reasons. We also thought about a cross gable at the entrance, but fear a structural change that could ultimately visually harm the object...
 

South

2021-02-11 20:18:53
  • #3


I have to ask again for dummies. Why is the south side suddenly supposed to be 2.80 meters instead of 2.30 meters? So eaves height 2.80 meters? I can’t imagine that looking at the pictures. But I’m probably missing something.

Personally, I would say that if the (dormer) gable either adapts to the historical conditions or, on the complete opposite, stands out as a modern eye-catcher, it can look very pleasing. However, of course, that is a matter of taste and cost.
 

derclaus

2021-02-11 20:43:04
  • #4


From the pictures, this cannot be determined – the wall visible there will be removed and replaced by a new wall (which will then be set back 60 cm inward). But that should not be the subject of my post – I am specifically concerned with the layout of the rooms on the ground floor.

Visually, I understand your opinion about the dormer gable. It can really look very nice but will probably not be considered for cost reasons.
 

derclaus

2021-02-11 20:47:34
  • #5


Because of the pillar and the beam: the beam is needed due to the extreme wind load on the building. The north wind exerted so much pressure on the roof that, for example, the south wall is completely crooked. Therefore, it has to be rebuilt (and will thus be set back about 60 cm inward to increase the height of the south side).

Okay, I don't have any more input regarding the pillar/beam or the south side and the corresponding height/eaves.

Thank you very much for your questions, which in turn encourage me to initiate one or the other topic.
 

ypg

2021-02-11 20:55:57
  • #6
I had the feeling that someone asked how you want to use the rooms without windows (from the memory above the bedroom). Would you like to tell me?
 

Similar topics
17.12.2015Wall on property boundary45
11.12.2015Question about floor plan, especially stairs13
02.05.2016Staircase floor plan design, tread and stringer21
12.07.2016Floor plan question, garage, stairs33
15.08.2016Technical room as small as possible - under the stairs?10
16.02.2017Straight staircase - why?14
06.03.2017Finishing staircase - parquet28
08.08.2019Overlap of one floor with the staircase11
07.07.2020Difference between dormer, cross gable, cross house - unclear development plan16
08.03.2022Cladding/Beautification of wall in the garden30
13.11.2020Space under the stairs not buildable17
25.07.2021LED strip ascending parallel to the staircase12
05.05.2021Stairs wrongly concreted, what now? Completion to the upper floor12
25.05.2021Straight staircase for single-family house: Are the dimensions okay?18
01.10.2021Clad open gallery with staircase12
02.02.2022Any ideas for redesigning the staircase?20
23.03.2023LED staircase lighting distances for curved stairs21
09.01.2023Design concrete path with stairs and wall area10
01.07.2023Layout question: Replace straight staircase with L-shaped staircase31
23.07.2023Get the stairs retiled and now the step is too high26

Oben