Build your own sauna with a sloping roof - suggestions/notes/plans

and it was approved by the woman.

.....WOW, so the ultimate goal has been reached. I think that's three levels above a professorship. Looks great, you would definitely have signed it like that before. I'll get in touch when it's my turn.......the sauna.

Have you ever sat on the bench at the same time as your wife, static or something?
But it looks great

.....WOW, so the ultimate goal achieved. I think that's three levels above a professorship.
Looks great, you probably would have signed off on that beforehand.
I’ll get in touch when it’s my turn.......the sauna.

Go ahead, one hand washes the other... ;) But only planning assistance, not execution. :D

Have you ever sat on the bench at the same time with your wife, static or something?
But it looks great

Yes, absolutely no problem.
Three of us already sat on it when only the frame was finished. The slats made it considerably more stable.
We’ll skip the foot, then you can easily sweep out, since the entire floor is virtually free.

But only planning assistance, not execution.

tsk tsk tsk.... these young people today....... lack of helpfulness from the older generation

I have to redo the oven protection again, without miter joints, I just can't get it to fit properly ...

Hi, a suggestion for the corners: simply shorten the strips a bit, then do not press the corners tightly together but slightly round off the mitered corners and then reattach them with a few millimeters of distance (using the same screws in the same holes). The distance then looks like a shadow gap and small unavoidable inaccuracies are not noticeable. Alternatively, glue the strips tightly at the miter before final assembly and connect them invisibly, concealed, or alternatively "nicely." Then mount them. There are plenty of YouTube videos for "nice" stable corner joints (biscuit joints, finger joints, etc.).

Cool, thanks for the tip. This could work.