Ventilation system in single-family house without effect = planning error?

  • Erstellt am 2021-02-01 19:35:25

jeti79

2021-02-10 10:01:16
  • #1
Yes, unfortunately I did not really engage with the topic much before the construction. I only learned about the "air well" during the construction phase. If I had known about it before, it definitely would have been integrated!
 

T_im_Norden

2021-02-10 15:25:31
  • #2
If you have the pump in the boiler set to automatic operation, the pump output usually increases when it gets colder. This then requires more electricity.
 

jeti79

2021-02-10 15:48:14
  • #3
That can of course be the case - unfortunately, I have no idea about that, and judging by the installer, he doesn’t either. So I’m hoping for the Wolf field service on 18.2 and adding that to "the list".
 

jeti79

2021-02-11 08:43:52
  • #4
Ok, as I already suspected, I had a wiring error with the power measuring sockets - the ventilation was connected behind the heater - which of course makes (no) sense o_O The heater therefore does not consume excessive power. According to the app, maybe 15-20% more than usual, which is completely fine. (approx. 0.8kWh per day) All the more I am annoyed about the power consumption of the ventilation system. :mad: One could have just worked with an air well or something similar, then this problem would probably be more or less history. Now the controlled residential ventilation currently consumes about 800-1000 watts during operation (at -12°C outside temperature). I have reset the flow rate in normal operation back to (the factory-set) 150 m³/h, hoping that the air quality will not suffer too much, but the air quality meter will tell me that... And my own nose should also "indicate" that. Attached again is the power consumption, which has obviously increased enormously since it has been below 0°C outside
 

Mycraft

2021-02-11 08:47:01
  • #5
You have a project for the summer.
 

jeti79

2021-02-11 08:54:13
  • #6

Unfortunately, it won't be that easy for me: The controlled living space ventilation system is located in the attic and we have underfloor heating everywhere. So getting through the house will be difficult. You would somehow have to get through the garage along the exterior wall, and I assume that over the length of the connection, the "air purification and tempering effects" would probably be minimized and promise little success. It simply wasn't planned for, and the plumber, for example, doesn't know anything about something like that.
 

Similar topics
26.07.2012Ventilation with controlled residential ventilation system15
27.02.2013Controlled residential ventilation or regulated air - experiences?14
30.04.2015KFW70 with gas-solar heating65
15.09.2022Central controlled residential ventilation with heat recovery: Are rooms individually controllable?20
15.12.2015Exhaust hood in controlled residential ventilation: Your experiences?30
09.05.2016Compliance with the 2016 Energy Saving Ordinance with the following heating14
21.01.2016Is the heating oversized?44
25.01.2016Which heating system would you choose for our planned new building?15
29.04.2016Which heating? Please provide recommendations27
09.09.2016Controlled residential ventilation and still open windows at night71
10.06.2019Controlled residential ventilation - Is stage 7 out of 9 an acceptable design?22
25.03.2019Electricity consumption air-to-water heat pump20
17.11.2019Manufacturer heating / controlled indoor ventilation wanted10
15.12.2022Electricity consumption at home, what is your consumption?418
14.12.2021Controlled residential ventilation (heat recovery) + air well + exhaust hood and "independent" chimney15
23.08.2022Can a geothermal basket precondition the air for controlled residential ventilation?26
15.12.2022Electricity consumption heat pump experiences?22
21.12.2023Power consumption of a heat pump65

Oben