Special size worktops and extraction hood question

Hello,

I also registered especially because there are such great tips here

I am also planning a kitchen and have quite a few problems.

For example, I want to place an 80 drawer cabinet Faktum against one wall so that I can attach a countertop with the dimensions 100*90 on top of it and, of course, to the wall. It should practically replace our table and I thought I could put another cabinet underneath.

But can I get such a countertop at Ikea? Preferably with rounded corners so it doesn’t hurt as much if you bump into it.

Where can I see where the hose connection of the extractor hoods is? My hole in the wall is 0.74 cm from the ceiling. Or measured from the floor with a room height of 245 cm, at 171 cm.
I have the feeling this could be too tight.

Thanks

no, it is only intended as a table and thus as a larger work surface. I have no intention of using chairs

practically as an island solution but only with a base cabinet.

Well, "extremely expensive" is really a matter of opinion. I think a laminate board with a normal edge costs about 80-100€, and other people invest completely different amounts in a kitchen. By the way, the depth is not the problem either, it goes up to 1.24m.

Regards

Drawer cabinet with an extra deep worktop above? Have you really thought that through well, how will you get to the top drawer or into it?

Hood, it could be tight, from the floor 171 cm - 90 cm worktop height - minimum distance cooktop vs. hood (assumed 60 cm) = 21 cm!
21 cm from the bottom edge of the hood to the motor connection and then straight into the wall box (pay attention to pipe bending) could be tight.

Best to go to Ikea, measure the hoods that are suitable in terms of appearance and performance, or have the salesperson measure them, you can hardly see the motor connection from the outside, dismantle the chimney.

Well, "extremely expensive" is really a matter of opinion. I think a laminate board with a normal edge costs about 80-100€, and other people invest completely different amounts in a kitchen. By the way, the depth is not a problem either, it goes up to 1.24m.

Regards

Personlig in that size for that price?
No way...
Maybe I'll calculate it on Tuesday if I manage to.

I want to add my two cents about the extractor hood:

With a usual height of around 85 cm for the countertop, the minimum height for the distance between the extractor and the electric stove of 60 cm, and the height of the extractor connection piece, which should be about 30 - 40 cm, I come to a height of 175 cm where the extractor connection piece would have to be... that’s not close, it just doesn’t work, since you still have to make the curve with the pipe.

Ultimately, it depends on the design of the hood and the height of your countertop. It will definitely be tight.