Problems with external devices, pass strips, and baseboards

So, regarding the oven: You simply buy a carcass for stove/sink and a 20 cm drawer with front. I assume the cabinet with the 10 cm panel is intended for cooktops if you use only a thin (1.8 cm) countertop. The freezer is probably ventilated from the back. If you install a base cabinet with a countertop above it for them, there will be problems. This could be solved with [ATTACH alt="probleme-mit-fremdgeraeten-passleisten-und-sockelleisten-189081-1.JPG" type="full"]27262[/ATTACH] and an oversized countertop. The installation manual should state how much space/air is needed there.

Förbättra is available in ivory white AND "normal white"!

Thanks! I found it now too, you really have to look closely.

As for the oven:
You simply buy a cabinet body for stove/sink and a 20 cm drawer with front.
I assume the cabinet with the 10 cm panel is intended for cooktops, in case you only use a thin (1.8 cm) countertop.

Good idea. I just thought such a common cabinet should be standard.

The freezer is probably ventilated from the back. If you install them a base cabinet with a countertop above, that will cause problems. Could be solved by
[ATTACH alt="probleme-mit-fremdgeraeten-passleisten-und-sockelleisten-189082-1.JPG" type="full"]27263[/ATTACH]
and an extra-deep countertop.
The installation manual should say how much space/air is needed there.

The freezer is 55 cm deep and needs 5 cm clearance at the back. So that roughly fits. I have also installed it in the previous kitchen in a base cabinet with ventilation in the cabinet and in the countertop.

Nachtvogel installed a 122 cm with a 120 cm door here. Maybe with some tinkering you can also do with a 100 cm door.

Great! This is really a very interesting thread.

Because I am now reading to you...... I bought all the parts individually. So the carcass in the desired height, then the desired fronts - or the interior fittings. I installed 4 tall cabinets and none was available in the complete range as desired. But that is exactly what I like so much about Ikea........I can mix and build myself however I want. A bit of craftsmanship doesn't hurt there..... Bye Sabine

So, the photos are taken............

here is the cabinet in the open state

you can clearly see that the refrigerator front is still larger than the rest of the refrigerator.
If I imagine it, it would be 20 cm more like this.

above, the iron trim of the refrigerator extends a bit over the upper base.
You can only see this from the refrigerator side.


below, the drawer front extends a bit over the refrigerator base.

Many a craftsman could take an example from this of what precise work means.

: Thank you very, very much for the photos and the great description in your other thread. That is really very helpful and super kind of you.

I have now measured the height of my refrigerator door, it is almost exactly 95 cm high. However, since the refrigerator has fixed door technology and the hinges extend 2.5 cm beyond the door at both the top and bottom and must also be covered from the front, the total height is exactly 100 cm. The 100 cm Sävedal front/door would therefore just fit.

Under the refrigerator, I would also use a drawer that slightly protrudes over the base of the refrigerator, just like in your photo. So far, that would also fit, but my next problem would be the microwave, which I have now planned above the refrigerator. It is only 38.8 cm high, so there would be an additional gap of 6 mm each below and above the microwave. Do you perhaps have any idea what could be done about that?