HELP!!! Ikea Under Cabinet FA120

Hello, I bought my entire kitchen at Ikea and now I have problems with the base cabinet FA120 (base cabinet with pull-out/drawer). I assembled the carcass and screwed in 4 drawer slides. Now a large front should be screwed onto the lowest slides. However, there are no drill holes on the front for this. It seems as if the front is wrong, because there are only 2 large holes for door hinges. Now I am at a loss and do not know whether the front is wrong or not. However, I think not everyone at home has a router and can work like a carpenter. Has anyone ever assembled such a cabinet and can tell me something about it?

Thank you very much in advance

Welcome to the Ikea forum!!

Hmm, I don't have the wardrobe, but you didn't accidentally attach the front panel on the back??

Otherwise, it may really be that you have to drill the screws in there with a cordless drill. Then it will hold much better than if there were already holes.

Regards, Sky

Hi, we can help you better if you could upload one or two photos.

Hello Narcisita,

Try the hotline. I've never called there before, but I wouldn't be surprised if IKEA also has a nice computer voice saying press 1, 2 or 3 – that can be quite annoying.

Good luck
Knut

Hello Narcisita,

I have two base cabinets from Faktum with the large front. For the doors, at least in my case, there was a paper template included. This was each time placed on the lower, opposite side and the holes that needed to be "drilled" were marked with a punch. Since I don’t know if you have the same door. For me, there were also 2 large and 4 small plugs included to cover the holes. One mounting hole went through the large plug. The doors are probably used for different models.

I hope I could help you

Good luck

Elch

Even though the thread is already older.....a look into the assembly instructions reveals quite a few secrets.

Best regards
Nordkäppchen