Attaching Ikea Metod front to RENGÖRA dishwasher

Hello,

I recently bought an Ikea kitchen including electrical appliances and am now struggling to attach the kitchen front to the dishwasher.

According to employees, the Ikea webshop, and all assembly instructions, the combination Metod - Rengöra requires the RESONLIG sliding hinge. Of course, I bought this as well, but unfortunately it does not fit the dishwasher at all.

1. The sliding elements are much too large and don’t even remotely fit into the grooves on the dishwasher intended for them.
2. The position of the grooves does not match the drilling template for the kitchen front, which came with the hinge.
3. The actual hinges also cannot be attached at the bottom of the dishwasher because the necessary screws are not present.

Could it possibly be that there is a newer model of the Rengöra, where the Resonlig hinge no longer fits, and a completely different one is actually needed?

The type plate on the side of the dishwasher door also shows a completely different article number than the one in the webshop.

Does anyone have a similar problem and a solution at hand?

Many thanks!
Christian

Hello,

The nameplate on the side of the dishwasher door actually shows a completely different article number than the one in the webshop.

Why don't you tell us the number(s) on the side...
Greetings,
IKEA-Friend

Hello, I almost have the same problem. Fully integrated dishwasher LAGAN, I am supposed to attach 2 fronts, I also first tried with RESONLIG sliding hinge, it didn't work (also no necessary screws for that at the dishwasher). Then I tried with hinges for ENASTÄENDE, it worked, I was able to attach the fronts, BUT when I open the dishwasher a little further, the whole front falls off.

and I also have no solution....

The article number is 402.993.81
Model Rengöra
Product number 911 535 072
Type GHE623DA1

There were different versions. You can see that on the exploded views. You would probably need Behjälplig, of which there are probably only leftovers left.