Wall tiles - edge finishing

No, on the wall to the left of the sink, near the end of the wall, there is a gap with very narrow tiles. Normally, you would do it so that the first one is rather halved, so that in the end you don’t get a stripe but something wider. Ideally, the width at the beginning and the end should be the same. Unless you wanted it that way, then it’s okay, although I would have had a stripe like that at the beginning (i.e., in the corner) as well. But as I said, that’s the case in many places for me, because I didn’t pay attention to it when the tilers were still here, and afterward they were unfortunately no longer reachable.

Yes, on the far left I had to cut the tiles. But I don't find it that bad. Your method that you suggested seemed too busy to me. The tiles are only 10x10, if you cut them smaller, there isn't much left. Then with the joints, it would be a striped pattern. It's okay as it is, I don't think it's bad. In the photo, the door frame can be seen. But the small strip on the left actually exists.

You, no problem, especially if you did it yourself, it’s great.

But just to explain what I mean, there is no grout anymore, the tile residue is just more evenly distributed, something like this:


instead of like this:


I think it’s more pleasing to the eye. But that might just be me.