Rohbauer has moved the windows by 10 cm

Then the error has vanished into thin air... In such cases, it sometimes helps to make a virtue out of necessity --> insulation of the [Laibung] on the right and left with 5 cm Styrodur each and then it fits again. Incidentally, it is recommended anyway to avoid thermal bridges, e.g. with a tilted window to prevent the masonry from cooling down.

Regards

No plastic comes near my house .... So, it will not be insulated. Besides, with your method, the window would only become 10cm smaller, wouldn't it?

Aha, and your floor slab is not insulated? What about the concrete ceiling? Is there no perimeter ceiling formwork around it? How are you insulating the roof, the roller shutter boxes, the foundation? With air and love?

Yes, the windows would be 10 cm smaller compared to the previous, "incorrect" wall opening, so then they would be exactly as large as they should be. Accordingly, the wall section will be larger. I would reconsider not insulating the reveals if I were you...

So it will be a KFW 55 house, I do think it has the necessary insulation. Only the masonry will not be insulated (36.5 Ytong).

If I make the windows 10 cm smaller, they will be smaller than planned. Because they did not make the wall 10 cm bigger, but shifted it by 10 cm.

But that has been clarified by now.

ops: ops: ops: embarrassing embarrassing ops: ops: ops:

I had compared the measurement with the old plan that we had signed, but in the project planning meeting this was apparently changed and with all the many changes I didn’t even notice this!

Sorry

I don’t understand. Who agreed on the changes with whom after the signature?