Electrical pre-installation for the front door, where should the cables be routed?

Hello everyone, it is currently still possible to lay a cable etc. to the built-in front door - for "later". Should the cable reach up to the "Schnapper", or where are cables usually laid when they are prewired for the front door? It is a fruit aluminum door.

Depends on what you want to do. Motor or automatic locks need power and potentially a few more wires depending on the control on the band side. For a latch, two wires at the strike plate are sufficient.

The door opener connection belongs in a protected area. Placing it in the outdoor intercom I consider reckless.

What exactly is needed should be discussed with the door manufacturer.

currently it would still be possible to lay a cable, etc. to the built-in front door - for "later".

Why only one? - lay some on both sides: for example, on the hinge side for a motor lock or the like, and on the latch side for an opener. Or even better, empty conduits.