Looking for assembly tips for Ikea Metod base cabinets

What forces the stove outward?

Lack of space: I have no more than 240 cm. The planned arrangement (from left to right): 1. Drawer cabinet 2. Sink cabinet (fixed because of water connection!) 3. Dishwasher (cannot be placed at the edge due to installation, also not suitable for position 1 due to lack of space when opening the lid) 4. Stove Then comes a door...

Dishwasher and stove could be swapped if an additional support panel were mounted next to the dishwasher. But since screwing an extra wooden strip to the countertop is already too complicated, that's probably out of the question.

You could also use 40 cm deep base cabinets behind the door. Screwing on a strip has a very good cost-benefit ratio. However, I suspect that 3 m long glued laminated boards from the hardware store don't look so good either.

@ Bianca13:
I have no idea how far you are now.
But I also had the idea with the hardware store board (already for logistical reasons), but if you deviate from the standard board depth (i.e. 60cm) it gets insanely expensive.
At least that was the case here, I almost got hyperventilation.

It's similar here, I have now obtained a 300x60x2.8 cm laminated board "Akazie". I will try to screw a strip of about 1.5 cm to the edge and then hide the whole thing under this [Fixa-Leiste]. If that doesn't fit, it will have to be extended more, or a proper wooden strip as a wall finishing strip will be needed.