Ikea Metod 20 drawers are nicer than the wire drawers

why should one want to retrofit additional rails? two rails are more than sufficient for the necessary load capacity of such narrow shelves, and you can still adjust the front height and front tilt on both sides, even if there is only one rail on one side.

I just thought that this could be a reason why the front sticks out. I have the 20-inch basket version, so I don't know the problem...

Do you know if the upper rail of the drawer can be adjusted in height?

In the assembly instructions on page 27 at step 22, it can be seen that the rear connection has several levels. Is it spaced at 5cm, so that you could go down up to two drill holes? You would just have to place the holes differently accordingly in step 6.

Hello everyone,

I still have the old grid version in my kitchen. Since this pull-out is absolutely awful, I would like to convert to the new one. Has anyone ever done this, especially in the installed state? I don't want to have to relayout the kitchen again because of this...

Best regards,
Simon

goes smoothly.
You can return the old inner part.

a cordless screwdriver with an angle attachment, e.g. Bosch ixo is advantageous in tight spaces...