Garage door - one large or two small ones?

  • Erstellt am 2019-07-15 15:54:37

11ant

2019-07-16 14:30:40
  • #1
Even if there really are two cars inside: after the construction, these are rarely two vehicles suitable for evening wear – instead, the beaten-up Mondeo estate acquired for personal work still has to wait a while until the credit line allows "appropriate" replacement again. That the gate reveals a view of an E-Class convertible and a Macan when raised usually only happens in the brochure.
 

SvBitzer

2019-07-16 21:00:51
  • #2
Hello, from a technical point of view, I can only agree that for "large" doors over 4.5 meters width, all well-known manufacturers deliver the execution of an industrial door in terms of panels, rollers, and frames. Doors with 6 meters width cause no problems, as long as they do not come from the low-budget range, but doors of the size of a double garage are fortunately rarely found in hardware stores. If you need advice or a recommendation for a specialist company with certified installers (proven experts), I am happy to assist you with advice and support.
Best regards, your door and drive technology expert S. Bitzer
 

AnSe2019

2019-07-17 06:23:54
  • #3
Thank you all for the opinions. Yes, I think both options have advantages and disadvantages. The construction manager also mentioned the possibility that there are wide doors that open to the side. Hard to describe, just that the rails are located on the right or left wall. This way you have the advantage that you can open the door just a little bit, but at the same time it has the appearance of a large door. I myself immediately thought that a screw or small object could easily fall into the rail, and then it’s over when you try to open it. can you say something about these doors? And thanks for your offer

Best regards
 

rick2018

2019-07-17 06:51:34
  • #4
Side-running doors are used when the garage is too low and there is sufficient width available. Depending on the model, you will be missing 15-30 cm on the side. Also, you cannot use the wall as a storage area, etc. Therefore, I recommend an insulated industrial sectional door with a high-speed roller shaft drive. There is a door manufacturer near us. A 5-meter door with full equipment costs under 4000€.
 

Domski

2019-07-17 07:53:10
  • #5
Does it come with the equipment for the junk room right away? (full equipment)
Joking aside: Hörmann says that for gates around 5 meters wide and in dark color, the gate can warp under full sunlight. However, it returns to normal when it cools down.

I would still advocate for the big gate. I have a garage + carport side by side, so also 2 driveways with a middle post, but for ... reasons and would have liked it to be solved differently. Now it's too late. :mad _O
 

AnSe2019

2019-07-17 08:15:27
  • #6
Also tend to the large gate. Shouldn't this now cost 3000 euros extra compared to the 2 smaller gates..
 

Similar topics
06.07.2011Garage directly attached to single-family house. Is the foundation sufficient?20
14.09.2012House financing - house, garage, and foundation slab approx. 290,000 EUR11
08.04.2015Install a technical room in the garage? Is this possible?35
19.08.2013Garage heating. What is the best / cheapest solution?10
08.01.2014Where do we put the house and garage?10
03.02.2014Cost estimate single-family house with garage11
30.07.2014Bungalow with 140 sqm and garage in the floor plan13
05.08.2014First offer, 157m2 with basement, KFW 70, garage14
05.09.2014Floor plan design of a 170m² passive house with garage18
05.11.2014Garage: design possibility of the roof, appearance14
26.11.2014House orientation / House entrance and garage14
18.01.2015Walkable garage (terrace)11
11.03.2015Planning optimal arrangement of house, garage, and driveway13
21.04.2015Is a floor plan with a garage feasible on the property?29
06.05.2015Draft single-family house with garage/carport - please provide evaluation22
18.05.2015Rainwater storage in the garage?11
11.06.2015Single-family house with a granny flat & garage14
15.06.2015Garage - Building Application - Confusion36
06.07.2023Garage on a hammerhead lot: Is turning possible?17

Oben