Faktum rational drawer dampers and under-sink installation

Regarding 1): what do the rails look like? For type B, there is a thread with pictures here: .
Regards,
IKEA-Freund

Hello everyone,

thanks so much for your answers already, you are my savior! :) I think I know now which dampers I need. It only depends on those two cutouts at the end of the rail, right? They are there! (see picture) Then the B dampers should probably fit. Thanks again for the hint that I also need the additional drawer front – otherwise I would have forgotten that :eek:
The linked slide says it measures 60x45 cm. Right under the sink there is an instantaneous water heater (or boiler? – no idea), which protrudes so far that 45 cm in depth would just barely fit... Can you risk that? Picture attached.

Here are the photos of the rail and the sink base:


Regards
Flashlight

Clearly B.

If there is about 45 cm of space up to the instantaneous water heater, the depth is not a problem. The siphon could be more of an issue. Isn't it a sink from Ikea?

I’m not sure if it’s a sink from Ikea. From the bottom board of the cabinet to the siphon, it’s something between 13.5 and 14 cm. The drawer has a height of 13.5 cm... If there’s anything added because of the rails on which the drawer is mounted, it could really get tight. I’m slowly starting to think the whole thing is too risky for me. The end piece of the drawer at the back is metal too, if I’m not mistaken. So it’s not something you can just “quickly make fit.” Investing around a hundred [currency] “on suspicion” without knowing if it fits is too risky for me.
Anyway, thanks a lot for your answers, I’m going to order the dampers for the drawers now! :)

Best regards, Taschenlampe

The vertical pipe, on the right in the picture, you can easily shorten a bit. The siphon can also be replaced with a space-saving siphon, so that the space in the drawer can be better utilized.