Division?! Small room / steep slope / radiator

I left out the windows on the outside because I do not know the height. On average, the 100cm height is visible. Section: the large triangle. 4 squares = 1 meter = 100 cm. The bed is drawn with 200 cm. Approximately 1 meter height results if you remove about 1.50 from the floor.

...if the DFFenster is lower, then you can make a windowsill on the Drempel in front of the window

I’m afraid the window is quite low, isn’t it? Go measure it!

The double casement window is 160 cm away from the corner (however, I measured from the corner at the bottom along the roof slope... so diagonally and not vertically)

I’m afraid the window is quite low, isn’t it? Go and measure!

The double casement window is 160 cm from the corner (however, I measured from the corner at the bottom along the sloping roof... so diagonally and not vertically)

But it doesn’t matter! The carpenter will make a board/finish for you in front of the window, whatever it may be.

Oh, that's what you meant by the 1.60m. According to the tangent, the height at a slope of 33 should then be about 1m, right? That would be much more than I thought.