Water pipeline for water backfeeding and irrigation

Ok. But I can swap the insert? I have already struggled a bit through the Doyma page, but I wasn't really sure if there are also further inserts for ours, where there is especially a hole for the brine in the middle and still smaller openings.

The hole is then no longer in the middle but further at the edge. You need to know the diameters and the quantity. Nothing more. You loosen the screws, causing the rubber to relax and no longer be jammed in the [Bohrung].

Ok. Thanks, I will discuss it again with the pool builder and installer to see if we can get another pipe out there. In principle, it should even be quite possible since the drilling is already quite large?

The borehole is more than sufficient to lay electricity through.

According to our drilling company, the brine pipeline must be 70cm away from other utility lines.

According to our drilling company, the brine pipe must be 70cm away from other supply lines.

According to our drilling company, the brine pipe must be 70cm away from other supply lines.

Doesn't this concern the inlet and outlet of the brine pipes so that the warm pipe does not draw heat from the cold pipe?