Problems with BEHJÄLPLIG

Hello,

I recently bought an Ikea kitchen, in which my already existing 45cm fully integrated dishwasher should also fit. So I bought a matching front at Ikea as well as Behjälplig. Unfortunately, I am having trouble with the installation of the sliding hinge. I followed the instructions completely and everything fit so far, the front is attached to the dishwasher. However, as soon as I want to open the dishwasher, the door of the dishwasher rubs against the sliding hinge already at about half opening. The further I open the door, the worse it gets. This certainly cannot be intended, right? Does anyone have an idea what I did wrong?

Could you take a few pictures for clarification? I have also used Behjälplig and had no problems.
Regards

Here is a photo of the problem:



I have marked the relevant spot.

In addition to the scratching noises and the visible material wear, it is especially bothersome that the door is difficult to close again when fully open.

Hello, I looked at your picture. There is at least half a centimeter of space for me. You glued or screwed the two "boards" with the guide onto the door, right? And the front, on which the aluminum rails are then attached, is placed from above into the guide, correct? As I said, I have enough space. Regards

Exactly, here you can see the two boards:



The black one is the dishwasher door, to which I screwed the two gray boards. I set the front into the guide from above and then snapped it in at the bottom into the two round holders. Actually, everything exactly according to the instructions. When closed, everything fits, the front sits exactly where it should.

Just like in the picture, it looks the same for me and the gap remains like that no matter how far the door is opened. I suspect that something is installed incorrectly at the bottom.