Ikea GODMORGON Mirror Cabinet Bathroom Light / Installation Instructions

  • Erstellt am 2011-02-13 09:59:00

flopi78

2012-06-18 09:11:58
  • #1
So I also had to attach a longer cable (where the cable comes out behind the light it really has to be thin so that the lamp can still snap in afterwards).

For me it never "clicked" either and I had to exchange the lamp. I think some lamps have a manufacturing defect (although the Ikea salesperson told me that no one has ever complained). In any case, the exchange helped. With the second (same) lamp the snapping in worked. The adhesive strips are not really necessary. The bracket should be screwed to the wall (with anchors).

Good *click*!
 

kerneloel

2013-09-02 22:46:09
  • #2
Even for me, the bathroom light Godmorgon didn’t CLICK.

I had bought the light on eBay because it was no longer available at IKEA. Therefore, I could not exchange it at IKEA for another light “with” CLICK.

Nevertheless, I found a solution for myself:

3 angle irons and a superglue (Loctite).

Since then, the light has been holding wonderfully, until now ...
 

maxomat

2014-02-01 15:25:05
  • #3
Hello everyone,

a question from a beginner here:

I have looked at the Godmorgon bathroom light and am considering hanging two of them. But I can't make sense of the assembly instructions (which are available online): They show the power cable somehow connected at the edge and inside. But where do these come from?

So my question is: How is the power cable routed from the wall to the connector?

Regards
Maxomat
 

IKEA-Experte

2014-02-01 17:53:54
  • #4
Hello,
that depends on how the cables are laid out at your place.
 

Godmorgon_

2014-12-13 16:32:18
  • #5
Godmorgon looks nice and gives a straightforward impression. But besides the already mentioned wiring, you also have to drill into the newly purchased mirror cabinet during installation to attach the amateurish-looking plastic clips. The brackets on the left and right with the tiny plastic hooks are also impossible and do not give a solid impression. This lamp was not worth its money!
 

Tazmann

2016-04-24 16:11:12
  • #6
Hello! Can someone help me with how to change the fluorescent tube in the Godmorgon bathroom light? I can't find anything on the internet and the assembly instructions don't really provide any information. Thank you very much
 

Similar topics
20.02.2014Ikea Kitchen Experiences – Your Opinions, Tips, and Recommendations Wanted!21
27.05.2016Feedback on the Ikea kitchen167
13.10.2017IKEA kitchen quality and experiences?140
13.12.2010Ikea Avsik, Faktum wall cabinet / Horizontal display cabinet door assembly20
24.07.2011Problems with installing the Ikea Inreda drawers from Besta16
29.01.2013Ikea Siphon Atlant venting/air release problem. It smells bad18
02.11.2011Pax / PAX Malm IKEA Assembly Instructions + Support for Sliding Doors10
26.05.2013Problem with IKEA PAX sliding doors14
27.07.2012Question about installing Ikea Värde wall cabinet 120x6013
14.08.2012IKEA PAX hinged door crooked, how can the problem be fixed?14
20.08.2015Storage shelf with door and drawer Inreda/IKEA, need help11
21.03.2013IKEA LAGAN DW60 - Water Supply Hose Extension13
01.12.2013Assembling Ikea Faktum drawer front11
13.01.2014Connect Ikea Inreda spotlight to the power grid11
14.05.2015Ikea Metod 40cm kitchen cabinet with drawers assembly tips10
12.04.2021Insert Ikea Utrusta base into kitchen corner wall cabinet10
06.12.2015Can the feet of the Ikea Norrsten sideboard be adjusted in height?13
04.02.2012Complaint Ikea Storm Floor Lamp13
24.10.2016Ikea Metod + BEHJÄLPLIG + Bosch Grundstück = Problem22
16.03.2023IKEA Godmorgon Cabinet - How to combine and attach?65

Oben