Hydraulic balancing, disable single room control?

So, the motors are labeled and disassembled.
These are the flow rates of the Taccos when they are (in my opinion!) turned up all the way!

no water is flowing at all, oops:

shouldn't the flow rates be much higher so that I can reduce them if the room gets too warm??

That's just how much your pump delivers. And the whole thing is connected. Where there is no more, there cannot be more.

Of course, you could still tinker with the pump, but I strongly advise against it.

It should be sufficient as it is.

Is there any heating cycle running at all? Otherwise, reading it off is useless.

Of course, you could still adjust the pump, but I strongly recommend not doing that.

He already did.

Is it getting warm? With gas, you might not need such a high volume flow.

I did not adjust any pump

I adjusted the flow regulators.

I also felt that until now only the tacos have been adjusted. Leave it like that for now and just observe what happens. Feel free to wait a few days as well.