First IKEA kitchen planning and some questions (external appliances)

I think it will not be a problem. In the assembly instructions for NYTTIG, you can see at what height the bottom is installed. The holes in the carcass always have a vertical distance of 50 mm.

Hi, the cooktop in the middle is only a problem if it is a 2.8 plate. Then the bottom is also a problem because it is too close to the cooktop. The easiest option is not to install the bottom. It doesn't make sense anyway. No other manufacturer uses something like that. The cooktop is completely wrapped in plastic, only fans are installed. The cable must be properly fastened at the back, that's all. With Metod, any common refrigerator can be installed. What I wonder is, is the socket for the hood in that spot? What about the window? That's at first glance. Best regards, Sascha

the cooktop in the middle is only a problem if it is a 2.8 cm plate

And how is that supposed to work without cutting anything out, when with a 38 mm plate the cooktop protrudes 15 mm from the countertop?

No other manufacturer uses something like this.

Miele does not require it. And otherwise?

Hi.
Why is it a problem with the 28mm plate when the partition under the plate creates 40mm and according to the manufacturer 65mm are required? It should fit then.
I am counting on the cutout between the carcasses. It should work, right?

Yes, the socket for the hood will be where we want it. That is why the kitchen planning is done early. The house is just being built and will be ready to move into next year.

The window is fine too. It will be at least 90cm sill height and will have a fixed section so that a faucet can be installed in front of it.

As for the corner cabinet, we followed your recommendation and replaced it with a 60cm base cabinet with 3 drawers.

Should work, right?

I think so too.