Connection part for overflow/IKEA/sink to siphon, where available?

  • Erstellt am 2012-08-27 15:04:18

conny-okd

2012-08-27 15:04:18
  • #1
I am a single mom and have been gifted an unused Ikea sink (1 basin/1 draining area with an overflow located directly in between) for my new kitchen. Unfortunately, the connection from the overflow to the siphon is missing, so the sink and the dishwasher cannot be connected. The sink is made of "hard plastic" (surface similar to granite) and was probably purchased at IKEA. There is no suitable connector at the hardware store, and unfortunately, I have not received any response from Ikea so far. The outlet of the overflow is very unusual and rather rare – it should be a part that can be slipped on, as the overflow does not end flush at the bottom, but rather as an "oval-rectangular pipe" about 3-4 cm long (awkward phrasing, but as a layperson I lack the technical terms here). The drain cannot be screwed onto the overflow (as is usual with other sink brands). Can someone help me with the following information: - what the part is called (possibly an item number from IKEA) - where I can get it Unfortunately, as a "newbie" I cannot upload a photo here – then everything would probably explain itself. ;o) Many thanks for your help!
 

conny-okd

2012-08-27 15:17:11
  • #2
Just added two pictures of the sink overflow (view from above and from below) to my gallery.

I am grateful for any tips. ;o)

Best regards,
Conny-okd
 

Nayla_1068

2012-08-27 18:09:10
  • #3
Hello,

are you absolutely sure that the sink is from Ikea? How old is it approximately?

Regards

Na.
 

conny-okd

2012-08-28 08:36:46
  • #4
According to the homeowner, the sink is really from IKEA. However, no one could tell me anything about its age. It looks totally new and modern, so I guess it can't be that old... In two hardware stores, I was told (independently) that the type of overflow is typical for IKEA.

Thank you very much for the link. Unfortunately, there was nothing suitable there either; here, too, the connection piece always has to be screwed onto the overflow or the overflow is located on the side of the basin...

So I'll just keep looking for a solution.
 

Maverick1854

2012-08-28 09:59:03
  • #5
Can you take a picture of the entire sink?
Somewhere underneath there is a sticker with an 8-digit number. That is the number from IKEA.
Is it still there?
 

Similar topics
20.02.2014Ikea Kitchen Experiences – Your Opinions, Tips, and Recommendations Wanted!21
27.05.2016Feedback on the Ikea kitchen167
13.10.2017IKEA kitchen quality and experiences?140
13.12.2010Ikea Avsik, Faktum wall cabinet / Horizontal display cabinet door assembly20
24.07.2011Problems with installing the Ikea Inreda drawers from Besta16
29.01.2013Ikea Siphon Atlant venting/air release problem. It smells bad18
05.02.2017Ikea GODMORGON Mirror Cabinet Bathroom Light / Installation Instructions12
02.11.2011Pax / PAX Malm IKEA Assembly Instructions + Support for Sliding Doors10
26.05.2013Problem with IKEA PAX sliding doors14
27.07.2012Question about installing Ikea Värde wall cabinet 120x6013
12.01.2017Ikea Atlant siphon and Domsjö sink14
09.02.2017IKEA Faktum legs/feet22
27.08.2016Ikea trash bin Hailo 3631-63 in Metod kitchen15
20.10.2015IKEA Metod Kitchen - Ideas / Suggestions for Planning?29
08.12.2015Ikea Metod kitchen installation - assembly tips?10
16.05.2016Our new first Ikea kitchen - planning and preparation69
13.07.2016Ikea Metod Bodbyn feedback wanted27
24.10.2016After moving: botched IKEA kitchen in the apartment14
26.03.2022Ikea kitchen planning - opinion wanted24
08.05.2022IKEA Metod kitchen quality 2022: Quality and price, experiences?35

Oben