Sealing problem with washbasin single-lever single-hole mixer 01092283

2016-02-01 14:38:25

I was then surprised during tightening that the metal disc scraped so much against the ceramic. After looking into the instruction manual, it was clear to me that the plastic naturally still has to go between the metal half-moon and the ceramic.

Here it is solved in such a way that a hard rubber is glued onto the half-moon - it is a finished part.

2016-02-01 14:42:28

ok. Then the plastic part underneath probably doesn't make sense.

2016-02-01 18:43:13

Moin Moin

Does the borehole have a consistent diameter of 35 mm throughout?
In the picture, it looks as if the 35 mm is only present at the beginning,

Olli

2016-02-01 18:45:22

Continuous? It’s a circle after all. How is the bore supposed to have an irregular diameter there?

2016-02-01 19:10:34

Did you possibly push the faucet forward or the threaded rod backward while tightening?

2016-02-01 19:13:04

Hello again

in one picture it just looks as if the borehole is not continuous.
How tight did you screw the nut?
Since the threaded rod is not centered, the front part pulls onto the WT first.

Olli

Similar topics
16.04.2020	Massive or wood / Drilling or trench collector	35
16.06.2021	Seal underground drilling	14
01.08.2022	How much space does the geothermal drilling require?	11

Sealing problem with washbasin single-lever single-hole mixer 01092283

MaxMumann

Musketier

wrobel

MaxMumann

Musketier

wrobel