Roof window blind solar or electric

The cable for this is then located in your insulation between the rafters. Here you only have to pass it through the membrane or, hopefully not, the foil. There are these penetration membranes for that, such as KAFLEX. From there, in the battens into the box of your electrician. I'll see if I can find a picture.

If you still write about integration into the smart home, you actually can't ignore Roto. You can also order 230V roof window shutters from Roto, then you can operate them normally with a blind actuator.

That was the plan, the electrician installs a roller shutter switch in the room with which you can then control the roof window blind like any other roller shutter. If we want to make it smart, we can simply install an underfloor actuator underneath like with the other roller shutters.

here you can see the two cables at the ceiling of the skylight which go sideways into a junction box.

In the picture, the cables on the wall are cut. Does this also work on the sloped ceiling?

Do you know on which side the Roto roller shutters need to be connected? So on which side the box should be placed?

According to the electrician, you must later go through the insulation and thermal insulation to get to the box.

The box is in the wall. You just have to run the cable from the skylight through the membrane, for which there is this adhesive, and then along the slanted ceiling into the box sideways in the wall. Your skylight will then be wired there.

He wants to install the box in the sloping roof directly next to the [Dachfenster]. The box should be able to be opened from the inside (remove the [Blindabdeckung]) and the cable should lie inside.