Lighting planning for single-family house with KNX

  • Erstellt am 2022-01-06 15:50:01

bowbow91

2022-01-06 15:50:01
  • #1
Hi everyone,

we are currently finalizing the electrical planning to, among other things, plan the corresponding outlets in the ceiling. What do you think about it and where do you see room for improvement?

Reading guide:
- Green: Spots in halogen boxes
- Red: Simple burning point (surface mounted e.g. spotlights or lamps)
- Yellow: Spot in drywall element (therefore number and position still variable)
- Green stripes: Drywall elements for light coves
- Yellow stripes: LED strips

I have framed and partially numbered the switching groups.



For the children's rooms and the office, I had thought about laying the cables as 5x1.5 to retrofitting a good lighting concept later, e.g. through suspended ceilings. Operation runs via KNX.

I will skip the planning for the basement with hallway at this point, as it’s standard. The floor plans do not exactly match the current work planning either, so do not judge the dimensions or similar; the architect will place the outlets correctly.

Best regards
 

Mycraft

2022-01-06 20:25:59
  • #2
Well, I would say. Back to the drawing board and start anew.

Once again way too many spots/recessed lights. Especially the hole orgy in the bathroom. What is the deeper meaning of all this? In the age of LEDs, what you intend can be achieved with significantly fewer individual light sources and also much more homogeneously. If you plan three light groups in the bathroom, just make three nicely shaped ceiling flush panels in round or square. These will provide more than enough light, possibly also in the TW variant (I would consider this anyway in a new build, if not already done),

8 lighting elements in a 20 sqm hallway is again at medical practice level.

Otherwise, yes, not bad in principle with many light groups. However, I might consider wall lights here and there and also backlighting in the media areas. Terrace and garden lighting.

Regarding the kitchen, it is not quite clear whether countertop lighting, etc. is planned.
 

guckuck2

2022-01-06 21:37:27
  • #3
Yes, just combine the spots, completely exaggerated. For example, one single spot over the toilet and shower is enough, maybe two in the shower.
 

Similar topics
02.11.2016Installing LEDs and energy-saving lamps17
13.02.2014Shower lighting walk-in shower14
31.03.2015LED ceiling spotlights in prefab house construction14
10.05.2015Recommendation for LED spots29
30.10.2015LED spots with wide beam angle10
27.04.2016Hanging ceiling for LED18
26.02.2017Ceiling above the shower - LED spots12
02.07.2019LED spots in the bathroom - where and how many?17
10.07.2017LED instead of halogen spot23
29.01.2018Lighting semi-detached house - Dali & DMX or REG-LED controller?21
26.01.2019Which light bulbs - only LED or others as well?41
05.02.20193x1.5 or 5x1.5 NYM in the roof box for LED spots?17
03.11.2019Lighting design with LED spots for hallway13
19.05.2020Lighting planning ceiling LED spots48
22.03.2021Planning of LED spots - Please provide tips19
07.04.2021Spot lighting / arrangement / quantity73
19.11.2021Stair lighting with LED strip13
23.03.2023LED staircase lighting distances for curved stairs21
30.01.2023Safely install electricity in the shower35
12.03.2025Lighting design for a multi-story apartment with indirect LED lighting50

Oben