fleptin
2016-07-28 14:39:45
- #1
Hello!
I have to plan a mini studio kitchen, where due to the special spatial conditions I have to plan a small L-shaped kitchen measuring 1.5x1.8m. Everything that fits in should go in there, so a domino cooktop, dishwasher, corner sink, etc., oven. Therefore, I want to place a tall cabinet at one end of the kitchen with a refrigerator and oven, which I have to somewhat "customize". According to the online planner, this option is not available, but the manuals of the planned oven and refrigerator allow the installation of the appliances in the same cabinet. I have planned Veddinge in white and want to build the cabinet as follows (from bottom to top):
8cm plinth
1.8 cm intermediate shelf
88cm niche for refrigerator (87.5cm built-in refrigerator with door-on-door mounting)
1.8 cm intermediate shelf
10cm cutlery drawer
60cm oven
10cm panel
1.2cm top side panel.
I want to solve the whole thing with Veddinge fronts in white and use a white 92cm Applad front from the Faktum reorder service as refrigerator cover. This then covers the 88cm niche for the refrigerator as well as the shelves above and below it.
I am of course aware that I will have to shorten a 200cm high corpus in height and will have to drill new holes for shelves and drawer rails at different heights because the changed heights of the installations will not match the hole grid.
Is the whole thing feasible? Above all, I am concerned about the height of the oven, which is between 110cm and 170cm in height. According to the official kitchen cabinets in the online planner, the oven is located at a height of 88cm to148cm.
I have to plan a mini studio kitchen, where due to the special spatial conditions I have to plan a small L-shaped kitchen measuring 1.5x1.8m. Everything that fits in should go in there, so a domino cooktop, dishwasher, corner sink, etc., oven. Therefore, I want to place a tall cabinet at one end of the kitchen with a refrigerator and oven, which I have to somewhat "customize". According to the online planner, this option is not available, but the manuals of the planned oven and refrigerator allow the installation of the appliances in the same cabinet. I have planned Veddinge in white and want to build the cabinet as follows (from bottom to top):
8cm plinth
1.8 cm intermediate shelf
88cm niche for refrigerator (87.5cm built-in refrigerator with door-on-door mounting)
1.8 cm intermediate shelf
10cm cutlery drawer
60cm oven
10cm panel
1.2cm top side panel.
I want to solve the whole thing with Veddinge fronts in white and use a white 92cm Applad front from the Faktum reorder service as refrigerator cover. This then covers the 88cm niche for the refrigerator as well as the shelves above and below it.
I am of course aware that I will have to shorten a 200cm high corpus in height and will have to drill new holes for shelves and drawer rails at different heights because the changed heights of the installations will not match the hole grid.
Is the whole thing feasible? Above all, I am concerned about the height of the oven, which is between 110cm and 170cm in height. According to the official kitchen cabinets in the online planner, the oven is located at a height of 88cm to148cm.