IKEA BESTA - Assembly Tips Stubbarp Feet for a Cabinet Wall

Besta is not solid, but rather lightweight construction.

I know, it bothers me a bit too. But I haven't found anything comparable that is just as beautifully modular as Besta. Do you know anything comparable?

Can you upload a sketch here?

Ok, I have created a sketch with the planner:

Oh dear, what a piece

You didn't put the feet under it. Try that. I think it looks strange.
Your TV stand is 64 high and the niche is then 90 cm high. Right?
Is that enough for a large device? I would only take the TV stand in 38 if you still want feet underneath.

Less is sometimes more...

Maybe you can also plan a bit of an offset on the wall. That loosens things up a bit.
Place the two tall cabinets without feet so that they stand about 5 cm forward. Hang the wall cabinets on rails. Choose the TV stand lower, put it on feet and pull it forward a bit.

Best regards

I have it similarly with me, without feet, I moved the middle lower block a bit forward, so I have space behind it and behind the tech wall for cabling, FritzBox, etc. see picture.



I installed an inspection shaft/covering behind the TV so that I can also access the sockets/FritzBox. A little space, a few centimeters away from the wall, is not so bad because of ventilation. Best regards, Robi

You didn't put feet underneath. Try that. I think it looks strange.
Your TV bench is 64 cm high and the niche is then 90 cm high. Right?

I haven't gotten the middle part yet. Maybe I'll take the small low board.

Place the two tall cabinets without feet so that they stick out about 5 cm to the front.

But I have baseboards. The tall cabinets will then be somewhat away from the wall. But the wall cabinets are directly on the wall, right? I would like them to be flush.

I have it similarly, without feet, I have shifted the middle lower unit a bit forward, so I have space behind it and behind the technology wall for cabling, Fritzbox etc.
see picture.

Looks great! How did you realize the top row? Are they resting on the left and right cabinets or are they part of the cabinets?

How is it possible that the middle part, which is hung on the rail, is perfectly flush with the left and right compartments? You can’t always drill a dowel hole millimeter-precisely depending on the nature of the wall.
Can you adjust something on the rail afterwards?

I have additionally connected the cabinets / carcasses with some furniture screws from the hardware store. Holds great and provides additional stability.

Best regards, robi