Fireplace with direct exhaust discharge through exhaust pipe

  • Erstellt am 2016-07-11 09:21:55

Sir_Kermit

2016-07-11 10:37:41
  • #1
Hi,


No matter what you do: try to get the chimney sweep on board beforehand, they like that.

About 15 years ago, we had to lead our condensing boiler outside with a concentric flue pipe. At that time, it was not allowed for this pipe to run through living rooms, but it could go through side spaces, and we were allowed to install 2 bends. According to Google, it seems that running through living rooms is now permitted, but without the master chimney sweep, you won’t get far. And whether that also works in modern houses is another question. Without precise advice, it can become a tricky dance.
One of our neighbors retrofitted a wood stove with a flue pipe, as there was no chimney. It goes straight through the exterior wall, then 1x 90 degrees upwards and past the roof overhang upwards. The height is another matter; if I recall correctly, our chimney had to end 1 meter above the ridge back then, which was changed back and forth.

Kermit
 

DragonyxXL

2016-07-11 11:44:59
  • #2
Thank you for the helpful tips. In our bungalow, the pipe would not pass through any additional living spaces. Through the Google keyword and an image found there, I discovered an interesting document.
Information sheet No. 47 Assessment aid for the inspection of combustion systems - Chimneys mounted on fireplaces without a base

It also states: "A base is not required for
a) Flue systems for fireplaces used only temporarily with a nominal heat output of not more
than 10 kW in detached, single-story buildings intended only for temporary occupancy, such as weekend houses, shelter huts, construction site cabins and accommodations on construction sites..."

The information sheet also highlights many other problems. Either the stove must bear the static load of the chimney or the ceiling must. Preventing rainwater ingress is more important, as otherwise the liquid will go directly into the stove. If the stove is ever replaced, it must be checked whether the pipe can still be used.

Apart from all the hurdles to be overcome, the solution does not seem possible for permanently occupied buildings/rooms.
 

Komposthaufen

2016-07-11 13:18:32
  • #3
We are planning a freestanding stove whose pipe goes vertically upward into the ceiling and from there through the upper floor and attic into a chimney. The chimney sweep did not see any insurmountable obstacles during an initial inspection. He will build the lightweight chimney (Promat or similar), which will stand on the upper floor floor, himself, hopefully making the final approval easier.
 

Similar topics
11.09.2019Controlled residential ventilation / DIBT stove / pressure monitor59
23.02.2015Air-water heat pump with solar thermal and fireplace? Cost/benefit/meaning34
07.02.2016Combination of air-water heat pump + solar thermal + stove or only stove and air-water heat pump13
30.03.2016Underpressure monitor / Chimney 4 Pa36
15.05.2016Experiences with fireplace with water jacket34
30.06.2016Fireplace for KFW 55 house22
21.03.2017Fireplace and carbon monoxide29
28.04.2016Height of cooktop/oven + length of countertops16
12.12.2017What is the minimum distance between a fireplace and a television?11
30.12.2017Heating system new construction (heat pump + stove + solar)35
22.01.2018Fireplace or stove in the Energy Saving Ordinance 2016 for new buildings10
20.02.2018Is an oven and ventilation sensible?31
11.06.2018Is a fireplace still useful in new buildings today - experiences?63
15.11.2018One-sided or double-sided fireplace50
27.05.2020Fireproof partition wall behind the fireplace?!11
17.12.2019Hanging fireplace - a good idea?10
05.02.2015The fireplace is not burning well13
23.11.2021What kind of spark protection is there in front of the fireplace??29
07.03.2024New funding for family home ownership201
13.02.2024Heat pump is not compatible with a water-bearing fireplace144

Oben