Cost of a stainless steel chimney

  • Erstellt am 2025-02-05 00:27:56

Bauer123

2025-02-05 19:06:25
  • #1
About exactly 2 years ago (energy crisis!) about 10% cheaper, however DN150 (is that enough?) at 9 m. Also wall and roof penetration. Measure has been coordinated with chimney sweep?
 

wiltshire

2025-02-06 05:31:39
  • #2
The stainless steel chimney for the masonry stove cost €3568.

Text from invoice 2019: The chimney system (stainless steel double-wall lightweight chimney) was installed and mounted from the ground floor up to approximately 1.80 m above the roof surface. This is a double-walled stainless steel chimney with F 90 fire protection. The chimney system was connected to the masonry stove on the ground floor (terrace) via a core bore through the house wall and a T-piece. A Coolblock was installed in the house wall for fire protection reasons. Stainless steel pipes in double wall were installed in the visible area up to under the ceiling. The chimney was integrated into the roof surface, sealed, and extended approximately 5 m above the roof surface. A chimney outlet piece with a rain cap serves as the chimney cover. Two inspection openings were installed in the chimney system for the chimney sweep.
 

ypg

2025-02-06 09:51:56
  • #3
Back then. We also about the same. However, no asparagus, that must have been at least 20cm wide. Considering that you don't get brackets or extensions for free either, plus the installation, then it fits.
 

Grundaus

2025-02-07 08:07:56
  • #4
180mm diameter is actually not standard and expensive. Roof penetration is expensive. If it is a timber frame house, the area around the pipe must be bricked up, which is also expensive. You have an offer with material prices and can compare them with the internet prices. A craftsman should only be 20-30% more expensive.
 

wiltshire

2025-02-07 08:40:01
  • #5
The pipe diameter is calculated based on the connected stoves. 180mm is a usual diameter. No, that is not necessary - see my previously posted offer keyword Coolblock. I am attaching a picture of the house penetration to the outside and see that I did not describe a penetration in the offer. So: The chimney of the main apartment has one penetration through the house wall, one through the flat roof over the terrace, and one through the tiled roof. Cost €3568.
 

Similar topics
22.01.2019Terrace with Plenera decking32
17.12.2013Floor plan single-family house with double garage and terrace19
25.02.2015Terrace with corner slabs (L-shape). Implementation of slope12
30.03.2016Stainless steel sink14
27.08.2016Different window heights on the ground floor and upper floor14
02.03.2017Detached garage on house wall - plaster?12
21.02.2017Development plan difference between ground floor, roof, and single-storey17
17.06.2019Filling the ground, protection of the house wall10
04.07.2022Moisture on the house wall outside and inside21
21.01.2020Stainless steel drinking water pipes, what are the disadvantages?15
12.02.2021Problems with stainless steel V2A? Experiences?15
15.01.2022Floor plan planning semi-detached house, ground floor assessment20
19.02.2023Sun protection for southwest terrace11
12.10.2023Liability question - fire protection correction in a semi-detached house11
26.10.2023Heating concept for new buildings - heat pump vs. masonry heater?18
28.05.2025Floor plan: who has the master bedroom on the ground floor?54
28.06.2024Bright up/down lights for house wall wanted14
02.10.2024Underfloor heating on the ground floor: insulate or not?16
31.10.2024Fixing wall purlin of terrace roof to house wall11

Oben