Solution proposals Bosch stove versus Ikea Metod base cabinet

Hello dear Ikea fan community, after I have now built my kitchen and installed the stove today, the following problem arose in addition to the uneven floors/walls that prevail in old buildings. The oven protrudes about 1.5 cm at the top. Installed is a Metod base cabinet for cooktop/sink 60x60x60cm, and to the left of it a Metod/Maximera 80x60x60cm, all with LIMHAMN support legs. Does anyone have an idea? Suggestions for solutions are welcome... Thanks & greetings Brochi

Hello,
do you have it?

Utrusta
Bracket for oven, galvanized

What is the intended distance to the cabinet bottom?

Hello,
only the corpus plus frame attached, nothing else. The distance to the cabinet bottom? I would say the oven lies flat.
Other base cabinets were not an option due to the desired uniform look (because of the legs).
Even the dishwasher was dropped from the planning since it would have also reached down to the floor.

Then you don't have the cabinet you linked, but one with a 60 cm high corpus. Which model from Bosch do you have?

Yeah right, I changed it .. ...I fear the worst... the 60x60x60 is for the cooking well .. Outside dimension 60 high inside logically smaller by the thickness of the base plate ... BOSCH HND 43 MS50 set with BOSCH HEG33U350 and BOSCH NKH645G17M .

What I am about to write now will not please you at all. The stove does not fit into the cabinet. Possible solutions: 1) Buy a 45 cm high oven. 2) Place decorative strips between the carcasses and the countertop. 3) Leave out the bottom of the cabinet, screw the side walls to the adjacent cabinets.