Single-family house, single storey, knee wall, upper floor window

  • Erstellt am 2016-05-27 19:05:20

ypg

2016-05-27 22:09:16
  • #1
Floor-to-ceiling? Where did I write that? You can place the window band higher than 30 cm, for example 60 cm, window 70 high, lintel... That fits on a 160 cm knee wall. You plan the terrace with gravel covering or a permeable surface. The roof overhang must be under 50 cm. I know that a gallery, meaning an opening in the upper floor slab, reduces the living area, but that would be nonsense, since this area would then be subtracted again from your upstairs living area. But actually every architect should know with which legal means one stays within the number of floors.
 

molchi

2016-05-27 22:19:46
  • #2
I just interpreted it that way! I'm also putting gravel on the terrace! The thing with architects is always a bit tricky! Some say one thing, others another! That's why I asked about the problem again here! On one side I have a dormer, with a knee wall of only 1.60m it gets very tight, probably not feasible. That's why I'm asking about peak wind speeds!
 

ypg

2016-05-27 22:26:58
  • #3
Try to raise a possibly lower knee wall with built-in cabinets. Simply mount sliding doors in front, with shelves and clothes rails behind them, then the lower slope visually disappears without any real loss of quality.

What is a friendly civil servant?
 

molchi

2016-05-27 23:19:17
  • #4
The extremely high knee wall is only important to me because of the windows! That’s why the maximum exploitation! Since you also belong to this area in the second part of your job title, at least as an employee, you surely know this professional field and can definitely interpret it! Will you tell me your LK in Ni?
 

Legurit

2016-05-27 23:30:45
  • #5
I don't believe any terrace will be taken off you - but okay. Our house has a footprint of 131 m² and we have 190 m² of living space - so your 121 m² should certainly be enough for 150-160. We have no dormers... with dormers and no tricks on the ground floor, a knee wall height of around ~1.2 m is more realistic - maybe 1.3 m. What kind of "architects" do you have there? Find one who actually charges money; they will surely know exactly and take responsibility for it.
 

ypg

2016-05-27 23:53:14
  • #6


Uh, what does it say about me? I am in the north, the extreme north
 

Similar topics
11.02.2015Cost planning for a single-family house including land, additional costs, architect32
09.04.2015For porthole, special regulations? Window, single-family house 1.5 stories.18
07.09.2015Kniestock height 2-story windows eaves side14
31.07.2016Electrical inspection, Q2, bathroom tiles, knee wall, floor-to-ceiling windows23
26.03.2017Raising knee walls: feasibility, costs, alternatives?10
02.02.2018Is the knee wall too low? What does the measurement refer to?22
25.04.2018Kniestock Danwood House in Schleswig-Holstein - What is the maximum possible?23
03.06.2018New construction of an approximately 8x11 semi-detached house, assessment of floor plan and windows35
27.12.2019Low ridge height results in a low knee wall55
01.07.2020Calculation for a single-family house with 175m² living area, basement, and double garage79
01.09.2020Are building plans with a 1m knee wall still up-to-date?16
22.08.2023Can a covered terrace be counted as living space?51
24.07.2021Extension or knee wall height increase?12
13.02.2021Only belief allowed, solutions?82
28.07.2021Utilize the plot ratio for new construction, build over the terrace21
02.11.2021Bathroom planning new construction - knee wall 1.80m13
09.04.2022Floor plan for a single-family house 150 sqm - window and bathroom planning18
14.09.2022Roof pitch and knee wall height when desiring a flat roof dormer26
20.05.2023Large dormers or high knee wall?33
27.06.2023How to achieve Bremer 2/3 solution with high knee wall?13

Oben