Pax Lyngdal IKEA sliding doors with drawers

Hello, we have now spent the whole weekend assembling our new Pax Lyngdal - there are 4 carcasses, 1 large, then in the middle 2 small ones, and then 1 large again. In the 2 middle carcasses, we each have 2 drawers. Now, on one side the drawers cannot be opened because the closet does not open completely (this is not visible to the naked eye, you only notice it because the drawers do not open). If you lift the doors a little at the bottom, they open enough to allow the drawers to be opened. The rails were all mounted straight and the entire closet was assembled step by step according to the instructions. Can someone give me a tip on what this could be?

Thank you in advance.

Best regards

Hello!
In the upper rail there is an adjustable stop installed (looks like a tooth lying on its side), have you already tried moving it slightly outward?

Otherwise PAX-LYNGDAL online manual, page 23.

Regards

If the drawers on only one side cannot be opened (they hit the door), and this cannot be resolved with the stops attached to the upper running rail, then the upper running rail is not aligned exactly in the center of the cabinet. The ends of the running rail must have exactly the same distance to the end of the cabinet on both sides. If this is not the case, then unmount the sliding doors again, dismantle the upper running rail, and reinstall it exactly in the center. Then, of course, reattach the door.