Ikea Pax Auli/Färvirk doors - Drawers hit against the sliding door

Hello everyone,

this weekend I assembled a Pax wardrobe with AULI/ Färvik doors.

2 * Pax corpus 100*58*236
1 * Auli/ Färvik sliding door pair 200*236
2 * Komplement drawer 100*58
2 * Komplement snap fitting
1 * Komplement drawer with glass front 100*58

Actually, everything went quite well so far. The doors are hung (the mirrored door on the left front side, the frosted glass door on the right back side). But when I inserted the first drawer at the bottom left, I had to realize that it cannot be pulled out. It hits the front sliding door. See also this picture:

What did I do wrong?

If it’s relevant: I haven’t installed the rails on the right and left yet.

Hello, the door probably needs to open further. Release the stop and try if it can be moved further outward.

Thank you very much for the reply! I have already pushed the stop as far outward as possible in the oval hole.

Could it be because I installed the "large" and the "small" stop, which is to be mounted inside for the locking system, reversed? I have now installed the large stop on the left (front sliding door) and the small stop on the right (rear door).

I am really at a loss...

Large, small stop? In any case, non-identical parts must be assembled exactly according to the instructions.

...I meant those metal brackets that came with the mounting kit for the snap fitting (for the quiet closing of the sliding doors). They are different sizes. I believe I installed them correctly.

Are there any other ideas what the cause could be?

First, examine where the door makes contact and thus prevents further opening.