Problem with PAX Ikea Lyngdal sliding doors, incorrectly hooked

hello, I assembled a Pax Lyngdal door last weekend.

I would check if the lower guides run in the corresponding rails (step 24).
Possibly also check the stop settings, although these normally do not allow a 10cm gap.

I myself had a problem hanging the 1st door because the switch (step 19) changed during the first hanging attempt (but I didn’t notice).

best regards

Look at the first post:

Tue 2 Mar 2010, 13:24

That was quite a while ago, wasn’t it????

I think the case has already been settled.

Regards Maverick1854

The tip from Balto also helped me. Thank you very much !!!

Dear Ikea fans. Thank you for your help. The tip with component "A" for the internal doors also helped me. I was already quite desperate....

Hello,

I have a problem with my PAX doors. The doors are high gloss white without glass.

Hanging them works, one on the front rail, the other on the rear rail, no problem BUT

The doors keep slipping out of the lower guide rail because the hanging things apparently are not properly seated. Does anyone have a tip on how I can proceed here?