Ikea Metod Maximera drawer protrudes at the bottom

  • Erstellt am 2019-09-27 19:42:00

Diekhadi

2019-09-27 19:42:00
  • #1
Hello,

I think I’m going crazy. Can someone help me and tell me why this drawer fits so well at the top but stands off at the bottom? I can’t figure it out.

Thanks in advance
 

seat88

2019-09-27 19:55:27
  • #2
Do the rails appear slightly tilted on the drawer body? Loosen all the screws and press the rail up at the back and down at the front while screwing it on. Or tighten the screws of the drawer at the bottom a bit more. The drawer might also just not be properly engaged in the rails at the back. To do this, open the slider and press something sturdy against the metal hooks of the rail at the back while gently trying to push against the slider...
 

Diekhadi

2019-09-27 20:03:46
  • #3
I will try it directly tomorrow, thanks for the quick response
 

Dr Hix

2019-09-28 15:01:23
  • #4
I would bet that you did not properly snap the front into place during assembly.
 

seat88

2019-09-28 15:50:09
  • #5
Could also be yes
 

Fummelbrett!

2019-09-28 17:26:31
  • #6
Pull the drawer out again, check if the rail is clean on it, if the front is snapped in - but I rather suspect that you can perfectly adjust that with the adjustment screws on the drawer.
 

Similar topics
06.08.2015Spice drawer - 15 cm or 30 cm?24
02.11.2023Kitchen appliances with black front39
20.08.2015Storage shelf with door and drawer Inreda/IKEA, need help11
15.11.2014Front for sink/waste combo10
27.01.2017Ikea Faktum: Baseboard and Drawer12
09.01.2012Bed SUNDNES - which screws?15
05.09.2012Drawer of Ikea Pax wardrobe no longer closes11
08.04.2013Looking for screws for old Ikea Billy shelf13
30.10.2020Handleless kitchen front, good and affordable - which manufacturer?63
31.03.2022Installing Ikea Maximera drawer into another brand kitchen23
27.03.2021IKEA Ivar dresser - drawer does not fit22
28.06.2023Dishwasher door broken off: Can it be screwed back on?20

Oben