IKEA Metod Häggeby Cabinet - Does a third-party oven fit, experiences

Hello dear community,

I have been researching diligently here for a few days, but now I have a question. We are in the process of redesigning our kitchen. The oven will be installed traditionally below the cooktop. For this, we have selected the appropriate Metod cabinet.


METOD / Förvara
Base cabinet for oven with drawers, white, HÄGGEBY white

As far as I know, the Ikea cabinets are intended for Ikea appliances. The dimensions, for example for the Raffinerad oven are as follows: W 59.5; D 56.4; H 59.5. For the oven we have selected, the sizes differ quite a bit: W 59.4; D 59.5; H 56.7.
Width and depth should not be a problem. But what about the height? Our oven is 2.8 cm shorter than the Ikea one. After installation, will we have a gap either under the countertop or below the oven?
Actually, I still have the plank from the old Faktum cabinet, which does not differ in width. However, I don’t know if we can install it without fuss )) and it has discolored after 11 years of use.
I would appreciate any answer )

Hello, that will be fine. Which oven is it?

That would be the one from Beko

You have shaken up the dimensions a bit.

Width: 594 mm
Height: 595 mm
Depth: 567 mm

Yes, and at Ikea the ovens are much higher, that's why the question was asked

No, the Beko is also 595 mm high (see your link). That's why mixed up ...
Regards,
IKEA-Friend