IKEA BLUMOTION Tipp On for Maximera Tandembox does not work

Hello,
I only see Tandem there, not Tandembox plus.
The Tandembox plus no longer exists. It was replaced by the Tandembox antaro. Maximera is similar to the Tandembox antaro, but unlike the RATIONELL drawers, it has a completely different side panel height.
The cabinet rails, as with RATIONELL, have a nominal length of 530 mm, which does not exist as a Blum standard. The holes for attaching the rails are also in different positions.
Tipp-On does not work with the BLUMOTION rails, and with the new Tipp-On with soft-close, special rails are also necessary. Until now, this was only available for the Legrabox. According to the Blum website, it will soon be available for the Tandembox as well.

For MAXIMERA, there is nothing except the Utrusta push-to-open mechanisms or the electric Blum Servodrives. I believe Robiffm has used the UTRUSTA push-to-open with drawers and it is said to work.

Hello Ikea expert,

thank you very much for the detailed response.

So with my newly installed Maximera drawers, the runners say "TANDEMBOX plus 30" and the larger ones "TANDEMBOX plus 50." And that’s why I searched for Tipp On and came across the different solutions for Tandembox plus. Still, the "new" Blum Tandembox plus rails apparently look different.

Hmm. Yes, I will try the Utrusta openers. There are also the Besta push door openers from IKEA. Maybe they would also work.

Regards, Christoph

The rails have not changed between Tandembox plus and antaro. For IKEA, there is an OEM version with an attachable damper, while in the regular Blum versions they are integrated. 30 and 50 refer to the maximum load capacity of the cabinet rails (30 kg, 50 kg). This is reduced in MAXIMERA due to the 13 mm thin bottoms. In Tandembox, 16 mm thick bottoms are used. BESTA push door openers differ from the UTRUSTA BLUMOTION only in the bracket.

Ok, if they are the same and I already have Tandembox Plus on mine, then the Tipp On modules linked above for clipping on should also fit, right? In any case, the description says that they are ONLY suitable for Tandembox plus. Has anyone tried it before? Otherwise, I'll just order them and if necessary, I can send them back.

Where does it say anything about Tandembox plus in the description?

Under "technical details":

Technical details:
Tip-ON for TANDEM drawer runners 50 kg without damping
Note only suitable for TANDEM plus
applicable for full extension 566HxxxC01
design for clipping onto the drawer slides