IKEA BESTA living room wall wall mount

Hello, I would trust the cabinet hangers less than the system from Ikea, since the sides of Besta are hollow and you then only attach the hangers to thin hardboard panels. As an alternative, I am thinking more of Hettich SAH 215.

Hi!

Thanks for your reply!
The system was just an example, it depends exactly on where these "Hartfaser Plattenstreifen" are. Is there any way to find out exactly where they are inserted?
In the Ikea system, the forces are also transferred through the plastic parts and these strips, right?
I just don't trust the short plastic pins...

Best regards, Chris

The "outer shell" of Besta consists of thin hard fiberboards. As internal reinforcement, strips of particleboard are glued in such a way that screws etc. to be attached find hold in them. If you now want to screw your holder SAH14 somewhere, you have a good chance that the screws will miss the particleboard strips and only be seated in the hard fiberboard (where they will tear out under load). Regards, IKEA-Friend

Hi, without wanting to be a smart aleck, but. you can also use dowels for these purposes. Regards robi

What use is a hollow wall plug if the forces then act again on the 2mm thick hard fiberboard?

The chipboard strips are where the holes for the shelves or the drawer rails are. The edge behind the back panel should also be made of this, because that is where the IKEA bracket grips.

Except at the mentioned locations, there will be nothing, otherwise everything could immediately be made of chipboard. That is why the carcasses are so light that the tall carcass already tips over with an open door when unloaded.