Adjust Ikea Hemnes display cabinet hinge

Hello,

how can the doors of the Hemnes display cases (502.271.19 102.271.16) be adjusted towards the hinge side?

Problem:
After assembling the carcass (everything is square, nothing crooked) and clipping in the door, it just fits into the door opening. Looking at the lateral centering, there is no gap on the free side, but about an 8mm gap on the hinge side.
The hinges allow only about 2mm of adjustment, but in the wrong direction (increasing the misalignment).
Looking at the position of the locking screw in the elongated hole of the hinge, it is factory-set in the middle; shifting it in the desired direction is not possible, only the other 50% of the elongated hole can be used.

How can I now center the door???

Thanks & regards!

Hello, 8 mm is already extremely much. For adjusting the hinge, it is too much. Have you checked whether the case shown in the second picture on p. 37 of the assembly instructions applies?

Hello Ikea expert,

yes, 8mm is a lot - and unsightly

Thanks for the note regarding page 37/2. I will take a closer look again, but I am quite sure I can rule this out.

Even in the disassembled state, that is, when I hold the two hinge parts in my hand, only the 1/2 sliding movement can be achieved.

Or what am I doing wrong?????

More than - 2mm hinges usually do not allow. If the problem is not solved yet, take some pictures.