Wall box: Breakthrough for extractor hood

Good morning,

I want to install a range hood with exhaust air in the kitchen because I also want to get rid of the moisture from the kitchen.

It is recommended to lay a 150mm duct to the outside.

Which wall box can you recommend?

It should be sealed, so that no air blows from outside to inside.

Thanks and regards,
Chris

Hello I have the wall box from Naber together with the Underverk extractor hood

With connection to round pipe Ø 150 mm and round stainless steel exterior cover. — Minimum pressure 150 Pa — Stainless steel cover Ø 220 mm — Hose/pipe connection Ø 150 a mm — Connection depth 24 mm — Installation depth 314 – 500 mm, wall breakthrough Ø approx. 155 mm — For the installation of the receiving pipe, a core hole drilling (Ø 155 mm) is recommended

and I am very satisfied with it. Due to the suction, the cover opens outside and closes when the suction is off. Best regards Section Chief

I picked up the wall box from Marley (Globus Markt) yesterday. The slats are fixed with a non-return flap. The hood also has a non-return flap. If dissatisfaction should occur after several months, I will have to replace it. But basically, I think you can't go too wrong.