Tiles: Have skirting boards cut or order them ready-made?

On the room sides where the long side of the tile is adjacent; but not on the sides where the narrow side (the 20) is adjacent; there would be 110cm of waste...

The cut edge is then vertical and therefore negligible. Or proceed as sco0ter suggests.

Only make finished baseboards if the available budget is still large enough. The additional cost is not to be underestimated.

The additional cost for finished products is about 100-120 EUR, still acceptable I think.

yes, for an additional €100 I would definitely choose ready-made baseboards

So the edges on the patterned tile were not sharp. You would then place the cut edge on the floor. From one tile, he would then cut two strips.

Also true again, only your waste might then be considerable. On the other hand, the ready-made purchased ones are also cut from normal formats, just on the calibration machine that strictly adds a rounding.

For 100€ in total, I wouldn't think twice.

You would still put 120cm baseboards where the narrow side meets. That means one baseboard would span 6 planks/tiles.

Really? And does that look good?

Really? And that looks good?

I wouldn’t know what should look bad about it. Otherwise, you would also have a joint every 20 cm, which you could avoid.

Besides: The ready-made ones also have their own length, I think about 60 cm.