Ikea Pax Uggdal drawers cannot be pulled out

Hello,

this week I set up the 2.50m wide Pax UGGDAL wardrobe. So 75 * 50 * 50 * 75. Today I wanted to install the drawers and had to find out that the drawers in the 50cm wardrobe sections cannot be pulled out because the doors cannot be slid open far enough for that. However, only about 2-3mm are missing, and the drawer would clear it.

Does anyone know what this could be caused by?

Thank you very much

Is that the same on both sides? Or only on one side? Normally it should work. Check again to see if there might be some play when moving the tracks.

Yes, that is the case on both sides. Nothing blocks the lower rails, only that one plastic part at the top (Bild 1), but that's supposed to be like that, right? I really don’t see anything I could work on :( For better understanding, I took a few pictures: Edit: I think it's resolved, the doors are not yet properly aligned. I’m going to hang them 100% straight now and hope that fixes the problem ;)