Ikea Pax sliding doors do not open fully

Hello everyone,

I took over a built Pax wardrobe with two sliding doors from the previous tenant and have now got 3 Komplement wire baskets with pull-out rails for it. However, before installing the baskets, I noticed that they cannot be pulled out at all because the sliding doors do not open fully.

Is there anything that can be done about it? I thought the Komplement fittings were specially designed to match the Pax wardrobes?

Thanks in advance for your help!

Hello, you must first investigate the cause as to why the doors cannot be fully opened.

There are stoppers at the top of the guide. It looks intentional to me - but it prevents you from pulling out drawers or baskets. Therefore, my question is whether this could be the intended design...

I do not recognize it and cannot assign it to any position. The excerpt is too small. How old is the PAX?

How old the cabinet is exactly, I unfortunately do not know. I think I was told an age of 2-3 years. What I referred to as the "Stopper" are the three protrusions on the inside of the left sliding door, which is shown in this photo. The last (here front) of the three stoppers may possibly hold the right, inner door. I am not sure about that, at least the door stops exactly at that height.

These are just indentations that give the fitting greater stability. However, they are also on the other side of the door. If it actually collides with the rear door, then compare the fitting with the one on the right side of the door to see if it is bent.