IKEA METOD wall cabinet horizontal with 2 doors

Hello dear community,

I am currently building my first (Ikea) kitchen and am partly at my wit's end. At the moment, I don't know how to proceed at the following point:

I bought this combination: Unfortunately, there is no assembly manual for the complete package; only how to assemble the carcass and how to insert a corresponding hinge are described individually. But here lies the problem. I installed the upper door along with the upper hinge as planned, and it fits perfectly; when closed, the door is exactly flush with the carcass at the top. However, the distance from the middle shelf to the next lower insertion position for the second hinge is significantly larger than the distance from the top of the carcass to the uppermost hole below for the first hinge. So if I were to install the second door now, it would hang about three centimeters too low, and there would be a gap between the doors. You can adjust a few millimeters with a hinge screw, but not such a huge difference! Is there a master plan here, or does anyone have a useful tip for me on how to properly install the second door?

A thousand thanks in advance for information.

Good morning, I thought the same during assembly. But it fits as you planned. The top door completely covers the body at the top, whereas the shelf in my case is definitely covered by both doors, therefore the distance from the holes upwards to the shelf is larger than from the upper compartment to the body. Best regards

Wonderful, thanks for the encouraging tip.
I will get started on it tomorrow.
Best regards