cinimini
2012-11-20 21:14:00
- #1
Hello,
I bought the sink cabinet with drawers (Item number: 598.688.19) and want to install it with the [Blankett grips], i.e. both at the top and on the middle piece between the fronts. The problem now is that the connection rails (117786 and 117785) of the drawer fronts would rest on the [Blankett grip], because there is only one drawer, but visually it looks as if there were two, which are only connected by the rails.
My question is therefore whether anyone has already installed a [Blankett grip] on the middle piece between the fronts and if that worked without any problems, or if you have to put washers under the screws so that the rail is not under tension in order to compensate for the height of the [Blankett grip]? Do the fronts stand crooked due to the height of the [Blankett]? And can you then see the rail above the [Blankett grip] from the front?
Thank you in advance for your help!
Lara
I bought the sink cabinet with drawers (Item number: 598.688.19) and want to install it with the [Blankett grips], i.e. both at the top and on the middle piece between the fronts. The problem now is that the connection rails (117786 and 117785) of the drawer fronts would rest on the [Blankett grip], because there is only one drawer, but visually it looks as if there were two, which are only connected by the rails.
My question is therefore whether anyone has already installed a [Blankett grip] on the middle piece between the fronts and if that worked without any problems, or if you have to put washers under the screws so that the rail is not under tension in order to compensate for the height of the [Blankett grip]? Do the fronts stand crooked due to the height of the [Blankett]? And can you then see the rail above the [Blankett grip] from the front?
Thank you in advance for your help!
Lara