How to measure the front for Ikea Maximera?

Good morning everyone,

unfortunately, my better half prevailed, so I did not buy an Ikea kitchen after all. And as it usually happens, something is missing from the new one. Namely, a pull-out drawer. So I got myself a tall Maximera pull-out drawer. It fit perfectly into my 60 cm base cabinet for the sink. But now I need to know where to drill the screws for the front. I need to know the distance of the holes from the side edge and the distance from the hole of the metal lock to the upper hole for the upper rail. Can someone please measure this for me?

Thanks and regards

Hello, I just measured a 60x40 cm front, I hope that's what you mean. Distance from the side to the center of the hole is 32mm. On each side, 6 holes are drilled, the distance of these measured from the bottom is: 39 mm 58 mm 117 mm 136 mm 185 mm 204 mm The measurements sound a bit strange, but that's how it is. Regards

Thank you for the information.
So, the distance between the lowest and highest hole that is needed.

The Utrusta drawer fitting stabilizes the high extension when mounting a tall front and includes a drilling template.

So you can calculate from the dimensions
204 mm - 39 mm = 165 mm

OK, thanks!!!
Didn’t know that it was exactly the topmost and bottommost where something is attached.